Categories
Contact Us

Shenzhen Huansheng Machinery Co.,Ltd.

 

Tel: +86-755-89265458
Fax: +86-755-89265459
E-mail: carl.liao@mycutcutter.com

Add: 17# Building, 228 Industrial Zone, Henggang Town, Longgang Dist, Shenzhen, China

Service Hotline
+86-755-89265458

News

Home > NewsContent

Woodworking Engraving Machine Do The Usual Protection

Shenzhen Huansheng Machinery Co.,Ltd | Updated: May 31, 2017

Factors that affect the quality of the grinding surface: As the grinding speed increases, the height of the grinding surface roughness decreases, the greater the feed rate of the workpiece, the height of the roughness of the machined surface decreases, the surface roughness decreases and the abrasive grain size Large, grinding surface roughness is smaller, the grinding pressure increases, the grinding depth increases, grinding surface quality decreases.

Woodworking engraving machine tool leading to wood fluff has also been affected by many factors, such as the blade point of view; blade into the corner; spindle accuracy; bearing wear; workpiece feed stability, is not able to think about large surface or loading And so on. But in general, mostly by the carpenter knife edge blunt, cut the amount caused by excessive. Most of the low density of the wood-based panel is the high incidence of burr, the use of appropriate tools, set the optimal carpenter mechanical equipment parameters, equipment and tools to do the usual protection is to make the wood cutting lubrication appearance.

1. Woodworking engraving machine to do the processing of acrylic cutting, recommended the use of single-edged helical cutter, wood processing is characterized by smokeless and tasteless, fast, high efficiency, non-sticky, really environmentally friendly, and its special manufacturing process to ensure that the processing of pressure grams Force not burst mouth, very fine knife pattern (even without knife), smooth and smooth surface. Processing surface to achieve frosted effect, recommend the use of double-edged three-edged helical cutter.

2. Woodworking engraving machine to do MDF cutting, recommend the use of double-edged chip chip cutter, it has two high-capacity chip flute, double-edged design, not only has a good chip removal function, but also very good Of the tool balance, in the processing of high density board, not black, no hats, long life and so on.

3. Woodworking engraving machine to do aluminum cutting processing, recommend the use of single-edged aluminum with a cutter. The process of non-stick knife, fast, high efficiency.

4. Woodworking engraving machine to do precision small relief processing, recommend the use of round bottom knife.

5. Woodworking engraving machine to do softwood, MDF, original wood, PVC, acrylic large deep relief processing, recommend the use of single-edged helical ball head cutter.

6. Woodworking engraving machine to do the following no burr cutting, recommend the use of single-edged, double-edged up and down cutter.

7. Woodworking engraving machine to do high-density board, solid wood processing recommended the use of edge milling cutter.

8. Woodworking engraving machine to do multi-layer board, plywood processing, recommend the use of double-edged straight slot cutter.

9. Woodworking engraving machine to do rough processing of particleboard and so recommend the use of multi-strip cutter.